Masataka Miyamasu and Kan Akatsu, “Efficiency Comparison between Brushless
DC Motor and Brushless AC Motor Considering Driving Method and Machine
Design”, IEEJ Journal Vol. 2 / No. 1 / Sec. D
Hiromu Arihara and Kan Akatsu, “Basic Properties of an Axial-Type Switched
Reluctance Motor”, IEEE Trans. on IA
Katsumi Yamazaki, Takashi Fukuoka, Kan Akatsu, Noriya Nakao, Alex Ruderman,
”Investigation of Locked Rotor Test for Estimation of Magnet PWM Carrier
Eddy Current Loss in Synchronous Machines”, IEEE Trans. on Magnetics
Natee Limsuwan , Takashi Kato, Chen-Yen Yu, Jun Tamura, David Reigosa,
Kan Akatsu and Robert D. Lorenz, “Secondary Resistive Losses with High-Frequency
Injection-Based Self-Sensing in IPM Machines”, IEEE Trans. on IA
査読付き国際学会
Hiroki Hijikata and Kan Akatsu,"Design Technique and Online Winding
Reconfigurations Method of MATRIX Motor",IEEE The 7th International
Power Electronics and Motion Control Conference (IPEMC2012), June 2012,
Harbin, China
Takanori Nagai, Gaku Ando, Kan Akatsu,"Consideration of CSI drive
for SRM compared with VSI drive" IEEE The 7th International Power
Electronics and Motion Control Conference (IPEMC2012), June 2012, Harbin,
China
Tomohiro Takahashi and Kan Akatsu,"A Drive System of PM Motor Using
Energy Harvesting",IEEE The 7th International Power Electronics and
Motion Control Conference (IPEMC2012), June 2012, Harbin, China
Takuya Yabe, Kan Akatsu , Nobunori Okui , Tetsuya Niikuni and Terunao Kawai,"Efficiency
Improvement of Regenerative Energy for EVs", EVS26, May 2012, Los
Angeles, United States of America
Noriya Nakao and Kan Akatsu,"Torque Control of a Switched Reluctance
Motor by Using Torque Estimation and Excitation Angle Control," IEEE
Energy Conversion Conference and Expo. (ECCE2012), September 2012, Raleigh,
NC
Hiroki Hijikata and Kan Akatsu,"Design and Online Winding Reconfigurations
Method of MATRIX Motor", IEEE Energy Conversion Conference and Expo.
(ECCE2012), September 2012, Raleigh, NC
Eri Zeze and Kan Akatsu, Research on Vibration Analysis and Noise Reduction
Technique of PM Motor, International Conference on Electrical Machine (ICEM2012),
September 2012, Marseille, France
Noriya Nakao and Kan Akatsu,"Simple Unipolar Excitations for SR Motors
Considering Fundamental Component of Self-inductance Distribution",
International Conference on Electrical Machines and Systems (ICEMS2012),
October 2012, Sapporo, Japan
Masataka Miyamasu and Kan Akatsu,"A Study of High Torque Surface-Mounted
Permanent Magnet Synchronous Motor by Maximum Utilization of the Magnet
Flux", International Conference on Electrical Machines and Systems
(ICEMS2012), October 2012, Sapporo, Japan
Tomohiro Yamada and Kan Akatsu, "Automatic Design Method Considering
the Frequently Used Area of a PMSM for an HEV", International Conference
on Electrical Machines and Systems (ICEMS2012), October 2012, Sapporo,
Japan
Masataka Miyamasu and Kan Akatsu, "An Approach to Generate High Reluctance
Torque in an Inset-type PMSM by Square Current Excitation", IEEE International
Conference on Power and Energy (PECON 2012), December 2012, Kota Kinabalu,
Malaysia
Hiroki Hijikata, Tomoaki Shigeta Kan Akatsu and Takashi Kato, "Experimental
Verification on Dual Winding Method for Compound Magnet Motive Forces Motor",
IEEE International Conference on Power and Energy (PECON 2012), December
2012, Kota Kinabalu, Malaysia
Takanori Nagai, Kan Akatsu, "Experimental Evaluation of A Current
Source Inverter for SRM", Korea-Japan Technical Workshop on Semiconductor
Power Converter (KJTWS 2012), November 2012 , Pohang , Korea
Naoya Kawakami and Kan Akatsu,"A Design of High Frequency High Power
Transformer", Korea-Japan Technical Workshop on Semiconductor Power
Converter (KJTWS 2012), November 2012 , Pohang , Korea